Gmc Steering Gear Box Shaft Sector Reports
22 Mar
GMC SONOMA 1998 | Stamped Aluminum Shaft Broke Off both driver and passenger side recliner releases within a week of each other.*ak |
GMC SIERRA 2000 | It Greatly Concerns Me That a failure in the power steering shaft occurs especially when it's happening to other people with the same truck. |
GMC SIERRA 2000 | The Power Steering Pump Shaft broke while backing, leaving the truck disabled in driveway. nlm |
GMC JIMMY 1997 | Steering Shaft Leakage Due To seal failure. mjs |
GMC SIERRA 1500 2004 | I Have A 2004 Z71 sierra truck with a 5.3 engine that has a speedometer problem. it reads 120mph all of the time |
GMC SIERRA 1500 2003 | I Have A 2003 Gmc sierra ext cab short bed pickup. at 24,000 miles i had to have the steering shaft replaced |
GMC SIERRA 1500 2003 | Dt*: The Contact Stated while driving various speeds on any road conditions, whenever the vehicle hit a bump in the road there was |
GMC 1500 2003 | Dt*: The Contact Stated that while driving 15 mph and making a right turn, there was a clunking noise under the hood, |
GMC SIERRA 2005 | Dt*: The Contact Stated the vehicle looses power steering at less than 5mph or while stopped and applying the brakes. the |
GMC 2500 HD 2003 | Looseness In The Steering Shaft. *jb |
GMC SIERRA 2002 | Dt: The Contact Stated That the intermediate steering shaft was replaced in february 2005 as suggested by a technical service recommendation. the nhtsa |
GMC SIERRA 2002 | Dt: 2002 Gmc Sierra. the consumer states the steering shaft bounced up and down, it was not correctly put in. |
GMC YUKON XL DENALI 2001 | Intermediate Steering Shaft I Was informed by the dealer that they had recalls on same suv but of different years, but failed |
GMC YUKON XL 2002 | Dt: The Steering Is Having a knocking sound when turning, and it is difficult to even turn the steering wheel. this |
GMC SIERRA 2003 | When Turning The Steering wheel completely to the left it will lock in this position and continue in a circle. |
GMC YUKON 1998 | Our 98 Gmc Yukon Should have 2 recalls, one for the wiper motor that everything the year upto ours was made had one & |
GMC PICKUP 2001 | The Hydraulic Pump And Shaft broke. as a result, the steering and brakes failed. then, vehicle crashed into a |
GMC YUKON XL 2002 | Owner Complained About A Steering shaft problem. the power steering became very difficult when driving. owner took the vehicle to a service |
GMC SIERRA 2003 | At About 20,000 Miles i started hearing a slight knocking noise in the steering while slightly turning to the right, and while |
GMC SIERRA 2003 | The Steering Column Experienced A cracking noise while driving 1-25 mph, and while making turns. vehicle was taken to the dealer, who |
GMC YUKON 2001 | The Steering Wheel Shakes Whenever making a turn, and there is a loud noise coming from the driveline. vehicle's performance continues |
GMC SIERRA 2004 | Consumer Was Unable To turn right or left. however, consumer was able to maintain control of the vehicle, and took |
GMC YUKON 2003 | While Driving And Attempting To make a left or right turn steering column locked in place. consumer had the vehicle serviced by a |
GMC 2500 HD 2003 | 2003 Gmc 3/4 Ton Pickup. problem with intermediate steering shaft. have a 1999 gmc 3/4 ton that the shaft has been replaced 6 |
On This Page
- Select and View Gmc Steering Gear Box Shaft Sector Problems
- Discuss Gmc Steering Gear Box Shaft Sector Problems
my system is leaking really bad on my 2001 gmc 2500 was told it is a power steering hydraulic booster can not find one anywhere Every time I move the tilt steering wheel up or down the windshield wipers operate for 2 or 3 swipes. Any ideas? Tom@losbanopsrelestate.com i just replaced the steering sensor and the truck still wanders and has play between 11 an 1 oclock any ideas what it could be sorry it is a 97 gmc yukon that i replaced the steering sensor on i replaced the steering sensor on my 97 gmc yukon it stop sliping but i still have play inbetween 11 and 1 oclock and tends to wander any idea whats wrong?
is this a re call