| PLYMOUTH VOYAGER 1993 |
When Left/right Frot Lower Ball joints are greased, grease can get on brake disc, contaminating brake pads, resulting in brake failure.
|
| PLYMOUTH BREEZE 1997 |
97 V 201 000/while Pulling into a parking lot right front lower ball joint broke. dealer contacted. feel free to provide any
|
|
|
| PLYMOUTH PROWLER 1999 |
Left Lower Ball Joint Snapped, and could have caused an accident. cause unknown. dealer notified. *ak
|
| PLYMOUTH BREEZE 1997 |
Lower Ball Joint Disconnected While driving at 25-30 mph. dealer contacted. feel free to provide any further information.*ak
|
| PLYMOUTH PROWLER 1999 |
While Driving 2 Mph And without warning, the lower right ball joint broke causing the right wheel to fall off, no accident occurred.
|
| PLYMOUTH PROWLER 1999 |
1st. Thing I Noticed a couple of months ago was the steering of the car was getting harder and harder to control, and
|
| PLYMOUTH BREEZE 1997 |
Recall Work Denied, Dealer denied service because vehicle was not purchased at location.(lower control arm ball joint).
|
| PLYMOUTH VOYAGER 1993 |
Lower Ball Joint Grease Overflows onto brake disc which, in turn, rotates the grease onto brake pads, causing front brake failure.
|
| PLYMOUTH NEON 2000 |
Tl*the Contact Owns A 2000 plymouth neon. while turning a corner at 5 mph, the contact heard a scraping noise.
|
| PLYMOUTH PROWLER 2001 |
Tl*- The Contact Said that the font spanking ball joint has a recall that has not been addressed. the contact said that
|
| PLYMOUTH BREEZE 1997 |
Upon Arriving Home From Work i backed the vehicle into my driveway and found the vehicle would not move and the passenger side front tire
|
| PLYMOUTH PROWLER 1999 |
The Dealership Was Unable To perform the lower control arm ball joint recall 03v-034000,the brake system lamp recall 99v-245000, the frame strength recall
|
| PLYMOUTH PROWLER 2001 |
Six Months Ago Consumer Received nhtsa recall 03v034000; concerning control arm ball joints. dealer still didn't have the proper tools to
|
| PLYMOUTH VOYAGER 2000 |
Ball Joints Factory Installed With no grease fittings dried out with no way to lubricate. causing popping, knocking noise under front end
|
| PLYMOUTH PROWLER 2000 |
Consumer Has Been Waiting Since march of 2003 for parts. suspension was broken. dealer stated parts were not available.*ak
|
| PLYMOUTH PROWLER 2001 |
While Driving At 55 Mph, consumer states vehicle took a nose dive into the pavement and suddenly drifted to the left hitting a concrete
|
Plymouth Suspension Front Control Arm Lower Ball Joint