Car-and-Safety.com

Ford E250 1988 Safety Reports and Reviews

Ford E250 Reports

FORD E250 Electrical System Wiring

FORD E250 1988 Electrical System Wiring Report #801984

FORD E250 1988 car safety problem was reported on Sept 08, 1996.FORD E250 1988, manufactured by FORD MOTOR COMPANY had a problem with ELECTRICAL SYSTEM:WIRING . EXPERIENCED AN ELECTRICAL FIRE IN VEHICLE. PLEASE GIVE MORE DETAILS. *AK.Vehicle was on fire. Ford E250 1988 problem was reported in MANALAPAN, NJ. Vehicle was not using ANTI-LOCK BRAKES. Vehicle was not using Cruise Control.
Report Your Car Problem Go Top

FORD E250 Engine And Engine Cooling Engine

FORD E250 1988 Engine And Engine Cooling Engine Report #527960

FORD E250 1988 car safety problem was reported on June 01, 1995.FORD E250 1988, manufactured by FORD MOTOR COMPANY had a problem with ENGINE AND ENGINE COOLING:ENGINE . OIL PAN LEAKS..0 person(s) died.Vehicle Identification Number (VIN):1FDMF60HOJV. Ford E250 1988 problem was reported in ORISKANY, NY. Original Owner. Vehicle was purchased on 19940810. Vehicle was not using ANTI-LOCK BRAKES. Vehicle was not using Cruise Control. Ford E250 1988 drive type:RWD. FUEL TYPE: GAS. Ford E250 1988 TRANSMISSION TYPE: AUTO.
Report Your Car Problem Go Top

Ford E250 1988 systems

Electrical System Wiring 1 Review(s)

Engine And Engine Cooling Engine 1 Review(s)

Share, Email, Print

Take a survey

Ford E250 1988 Reviews

my 95 ford exploere engine surges when turn my air conditioner on

Ihave a 1994 ford probe which has started to idle very low and stalls at times. It is a 4 cyl. w/ air and a 5 speed. any ideas? I replaced the fuel filter, air flow meter and added HEAT to gas tank to dry and clean fuel system. I think my pcv valv

should a standard transmission truck start when it is in gear without the clucth engaged?

should a 2005 standard transmission ford ranger start when in gear without the clutch engaged?

96 Ford F250 Emergency brake lever gets caught on the auto adjustment spring, causing brakes to be permanently engaged, also allowing the parking break lever to rub against the hub, which can cut through over time.

try pushing the pedals button closer to you. you must have the pedal adjustment button to the left of the radio, looks like a foot, that brings the pedals more inward towards the driver. hope it helped. or look carefully if a wire has corroded. it

i would check ur multi switch on ur stearing colum

on the pedal

whats the sound

Just bought an '06 E-350 van. Left d'ship got on highway and noticed shimmy when I got to 60....same problem????

that happened to me last night! If you rock the car back and for while shifting then it should release the safety lock!

why does it take turning off the veh. while pulling in on the shifter arm, them starting it again while still holding it inwards ever so slightly??