Car-and-Safety.com

Ford E250 1979 Safety Reports and Reviews



Ford E250 Reports


FORD E250 Engine And Engine Cooling Exhaust System Manifold/header/muffler/tail Pipe

FORD E250 1979 Engine And Engine Cooling Exhaust System Manifold/header/muffler/tail Pipe Report #10027157

FORD E250 1979 car safety problem was reported on .FORD E250 1979, manufactured by FORD MOTOR COMPANY had a problem with ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:MANIFOLD/HEADER/MUFFLER/TAIL PIPE . THE EXHAUST MANIFOLD IS CRACKED ON THE RIGHT SIDE WHICH CAUSES THE EXHAUST GASES TO ENTER THE ENGINE COMPARTMENT. *AK.Ford E250 1979 problem was reported in BUCYRUS, OH. Original Owner. Vehicle was not using ANTI-LOCK BRAKES. Vehicle was not using Cruise Control.
     Report Your Car Problem      Go Top

Ford E250 1979 systems


Share, Email, Print



Take a survey



Ford E250 1979 Reviews


my 95 ford exploere engine surges when turn my air conditioner on

Ihave a 1994 ford probe which has started to idle very low and stalls at times. It is a 4 cyl. w/ air and a 5 speed. any ideas? I replaced the fuel filter, air flow meter and added HEAT to gas tank to dry and clean fuel system. I think my pcv valv

should a standard transmission truck start when it is in gear without the clucth engaged?

should a 2005 standard transmission ford ranger start when in gear without the clutch engaged?

96 Ford F250 Emergency brake lever gets caught on the auto adjustment spring, causing brakes to be permanently engaged, also allowing the parking break lever to rub against the hub, which can cut through over time.

try pushing the pedals button closer to you. you must have the pedal adjustment button to the left of the radio, looks like a foot, that brings the pedals more inward towards the driver. hope it helped. or look carefully if a wire has corroded. it

i would check ur multi switch on ur stearing colum

on the pedal

whats the sound

Just bought an '06 E-350 van. Left d'ship got on highway and noticed shimmy when I got to 60....same problem????

that happened to me last night! If you rock the car back and for while shifting then it should release the safety lock!

why does it take turning off the veh. while pulling in on the shifter arm, them starting it again while still holding it inwards ever so slightly??


Discuss FORD E250 1979


No comments have been provided.


Ford E250 1979 Recalls


ON THE INVOLVED VEHICLES, THE POTENTIAL EXISTS FOR THE OUTBOARD SEAT BELTS TO BECOME TRAPPED IN THE SEAT-BED PIVOTING MECHANISM. SHOULD THE BELT BECOME TRAPPED IN THE MECHANISM WHEN THE SEAT IS CONVER...

THE INVOLVED VEHICLES WERE PRODUCED WITH BRAKE PUSH-ROD TO BRAKE PEDAL RETAINING PINS WHICH WERE NOT HEAT-TREATED AS SPECIFIED. THIS COULD ALLOW THE BRAKE PEDAL TO BECOME DISENGAGED FROM THE PUSH-ROD....

CERTAIN VEHICLES MAY NOT CONTAIN THE SPECIFIED BODY MOUNTED HEAT SHIELDS. THIS COULD CAUSE HIGH FLOOR PAN TEMPERATURES WHEN THE ENGINE IS IDLED FOR EXTENDED PERIODS OF TIME. FOULED SPARK PLUGS OR OTHE...

THE INCORRECTLY INSTALLED LEFT FRONT BRAKE HOSES MAY ALLOW FOR CONTACT BETWEEN THE FRONT BRAKE HOSES AND THE FRONT TIRES WHEN THE FRONT WHEELS ARE IN FULL RIGHT OR LEFT TURN POSITIONS. IF CONTACT IS M...

Ford E250 1979 Service Bulletins


FORD E250 1979