Car-and-Safety.com

Ford E250 1978 Safety Reports and Reviews



Ford E250 Reports


FORD E250 Structure Frame And Members

FORD E250 1978 Structure Frame And Members Report #732058

FORD E250 1978 car safety problem was reported on .FORD E250 1978, manufactured by FORD MOTOR COMPANY had a problem with STRUCTURE:FRAME AND MEMBERS . WE HAVE HAD THIS VAN FOR A NUMBER OF YEARS. IT IS NOT USED MUCH NOW. THE PROBLEM IS THE WHEELS DO NOT TRACK. THE FRONT WHEELS ARE OFFSET TO THE LEFT, WHEN LOOKING FORWARD. I HAVE NOTICED THIS ON MANY OTHER FORD E TYPE VANS AND F TYPE PICKUP TRUCKS ON THE HIGHWAY. THE BODY OF THESE AFFECTED VEHICLES SEEMS TO BE CANTED, NOT GOING STRAIGHT DOWN THE HIGHWAY. IT WOULD SEEM THAT THIS WOULD PUT LATERAL FORCES ON THE TIRES, ETC. CAUSING EXCESSIVE WEAR AND OTHER PROBLEMS. I AM NOT LOOKING FOR MFGR. SUPPORT AND ONLY SENDING THIS FOR INFORMATIONAL PURPOSES BASED ON CURRENT TIRE PROBLEMS WITH FORD VEHICLES. *AK.Ford E250 1978 problem was reported in PHOENIX, AZ. Vehicle was purchased on 19790501. Vehicle was not using ANTI-LOCK BRAKES. Vehicle was not using Cruise Control. Ford E250 1978 drive type:RWD. FUEL TYPE: GAS.
     Report Your Car Problem      Go Top

Ford E250 1978 systems


Share, Email, Print



Take a survey



Ford E250 1978 Reviews


my 95 ford exploere engine surges when turn my air conditioner on

Ihave a 1994 ford probe which has started to idle very low and stalls at times. It is a 4 cyl. w/ air and a 5 speed. any ideas? I replaced the fuel filter, air flow meter and added HEAT to gas tank to dry and clean fuel system. I think my pcv valv

should a standard transmission truck start when it is in gear without the clucth engaged?

should a 2005 standard transmission ford ranger start when in gear without the clutch engaged?

96 Ford F250 Emergency brake lever gets caught on the auto adjustment spring, causing brakes to be permanently engaged, also allowing the parking break lever to rub against the hub, which can cut through over time.

try pushing the pedals button closer to you. you must have the pedal adjustment button to the left of the radio, looks like a foot, that brings the pedals more inward towards the driver. hope it helped. or look carefully if a wire has corroded. it

i would check ur multi switch on ur stearing colum

on the pedal

whats the sound

Just bought an '06 E-350 van. Left d'ship got on highway and noticed shimmy when I got to 60....same problem????

that happened to me last night! If you rock the car back and for while shifting then it should release the safety lock!

why does it take turning off the veh. while pulling in on the shifter arm, them starting it again while still holding it inwards ever so slightly??


Discuss FORD E250 1978


No comments have been provided.


Ford E250 1978 Recalls


THE SHIFT SELECTOR REACTION SPRINGS MAY BE DEFORMED AS A RESULT OF IMPROPER INSTALLATION OF SELECTOR LEVERS DURING COLUMN BUILDUP. THUS THE LEVER MAY NOT BE ABLE TO BE MOVED INTO THE INSERT DETENTS LO...

SOME OF THE INVOLVED VEHICLES MAY HAVE DEFECTIVE CARBURETORS IN WHICH, UNDER CERTAIN CIRCUMSTANCES, THE SECONDARY THROTTLE PLATES MAY STICK OPEN....

ON THE INVOLVED VEHICLES, THE STEERING TIE ROD AND LINK ASSEMBLIES WITH ADJUSTING SLEEVE CLAMPS MAY HAVE BEEN IMPROPERLY MANUFACTURED. THE CLAMPS CONTAIN A SHARP DIE MARK WHICH COULD CAUSE THE CLAMP T...

ON THE INVOLVED VEHICLES, LEAKAGE MAY OCCUR AT THE THREADED CARBURETOR-TO-FUEL FILTER CONNECTION ON THE SUSPECT CARBURETORS. THIS IS DUE TO AN IMPROPERLY MACHINED CARBURETOR FUEL INLET CONNECTION....

ON THE INVOLVED VEHICLES, THE PARK ACTUATION SUPPORT PLATES ARE DEFECTIVE DUE TO THEIR SUSCEPTIBILITY TO CRACKING DUE TO IMPROPER HEAT TREATMENT DURING MANUFACTURE. AS A RESULT, FRAGMENTS FROM A BROKE...

CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHIC...

Ford E250 1978 Service Bulletins


FORD E250 1978