Car-and-Safety.com
Nissan Safety Belt 9999 Safety Reports and Reviews
Nissan Safety Belt Reports
NISSAN SAFETY BELT Child Seat Retractor
NISSAN SAFETY BELT 9999 Safety Review #10018632
NISSAN SAFETY BELT 9999 car safety problem was reported on May 13, 2003.NISSAN SAFETY BELT 9999, manufactured by NISSAN NORTH AMERICA, INC. had a problem with CHILD SEAT:RETRACTOR . ENGINE KNOCK,ENGINE FAILURE, REPLACE CORRODED THROTTLE BODY, GAS SMELL LEAKS INTO INTERIOR, FAULTY FRONT PASSENGER SEAT BELT RESTRAINT,VEHICLE NOW HAS 110,000 MILES ON IT AND IS IN THE SHOP FOR A NEW FUEL PUMP. EXCESSIVE NOISE POLLUTION WHEN DRIVING, FAULTY REAR HATCH LOCK(ELECTRICAL), FAULTY ELECT. PWR. DOOR LOCKS, LOCKS WHEN NOT TOUCHED. THIS VEHICLE IS WHAT LEMON LAWS WERE INTENDED FOR YET NISSAN IS IN DENIAL ABOUT ALL THE PROBLEMS OWNERS HAVE ENDURED WITH NO COMPENSATION. *JB.Nissan Safety Belt 9999 problem was reported in BARNEGAT, NJ. Vehicle was not using Cruise Control.
Report Your Car Problem Go Top
NISSAN SAFETY BELT Child Seat Harness
NISSAN SAFETY BELT 9999 Safety Review #10185306
NISSAN SAFETY BELT 9999 car safety problem was reported on Mar 07, 2005.NISSAN SAFETY BELT 9999, manufactured by NISSAN NORTH AMERICA, INC. had a problem with CHILD SEAT: HARNESS . BOUGHT NISSAN MAXIMA 2005 IN MARCH OF 2005. STARTED WITH SHAKING STEERING WHEEL FROM 55 MPH AND ABOVE. TOOK IT BACK SEVERAL TIMES TO PREMIUM NISSAN, NEW ROCHELLE. REPLACED BRAKES, ROTORS, STRUTS, RIMS AND TYRES. ALSO BODY REPAIRS LIKE SWAYING REAR FENDER AND VIBRATING HEAT SHIELD IN ENGINE. STILL HAVE SHAKING PROBLEMS, CANNOT ROTATE TYRES AND SPEED BALANCED OVER 7 TIMES AND NO SOLUTION. LOST BBB ARBITRATION AND CONSUMER AFFAIRS HEARING. ON 3/7/07 TOOK FOR SERVICE AND NISSAN DID RECALLS TO REAR SUSPENSION ABS AND CHILD SEAT ANCHORS. THEY ROTATED THE TYRES AND NOW THE CAR PULLS TO THE LEFT AND THE RIGHT ON ROUGH ROADS (TOTAL NIGHTMARE). .Nissan Safety Belt 9999 problem was reported in BRONX, NY. Vehicle was not using Cruise Control. TYPE OF CHILD SEAT CODE: BLISTER. INSTALLATION SYSTEM CODE: LATCH SYSTEM.
Report Your Car Problem Go Top
NISSAN SAFETY BELT 9999 Safety Review #10238093
NISSAN SAFETY BELT 9999 car safety problem was reported on Jan 01, 2008.NISSAN SAFETY BELT 9999, manufactured by NISSAN NORTH AMERICA, INC. had a problem with CHILD SEAT . THE PASSENGER SIDE AIRBAG WARNING LIGHT BEGAN FLASHING ONGOING RIGHT AFTER THE CAR'S WARRANTY EXPIRED AT 60,000. UPON RESEARCHING IT WAS DETERMINED THAT A FAULTY AIRBAG SENSOR WAS TO BLAME ON THIS 6 YEAR OLD CAR AND THAT SINCE CAR WAS NO LONGER UNDER WARRANTY THAT IT WOULD COST OVER $1,000 TO REPLACE THIS FAULTY SENSOR. MOST MANUFACTURERS INDICATE THAT THE LIFE OF THEIR AIRBAG EQUIPMENT IS BETWEEN 10-15 YEARS. MERCEDES-BENZ ORIGINALLY STATED THE AIRBAG SHOULD BE REPLACED DURING NORMAL SERVICE AT THE CUSTOMER?S COST AFTER FIFTEEN YEARS BUT BOTH MERCEDES-BENZ AND AUDI NOW SAY THE UNITS SHOULD LAST THE LIFE OF THE VEHICLE AND INFINITI IS UNWILLING TO STAND BEHIND THEIR PRODUCT AFTER ONLY 6 YEARS. *TR.Nissan Safety Belt 9999 problem was reported in FAIRFIELD, CT. Vehicle was not using Cruise Control. DATE OF MANUFACTURE: 20080101.
Report Your Car Problem Go Top
NISSAN SAFETY BELT Child Seat Latch Connector
NISSAN SAFETY BELT 9999 Safety Review #10245310
NISSAN SAFETY BELT 9999 car safety problem was reported on Oct 13, 2008.NISSAN SAFETY BELT 9999, manufactured by NISSAN NORTH AMERICA, INC. had a problem with CHILD SEAT:LATCH CONNECTOR . 1995 NISSAN PATHFINDER XE FRAME ROT, SCALING AND FAULTY MANIFOLD STUDS OR MANIFOLD (RELATED VEHICLE INFORMATION: MODEL YEAR=1995, MAKE=NISSAN, MODEL=PATHFINDER). *TR.Nissan Safety Belt 9999 problem was reported in HUNTINGTON, MA. Vehicle was not using Cruise Control. DATE OF MANUFACTURE: 19950101. TYPE OF CHILD SEAT CODE: INFANT.
Report Your Car Problem Go Top
NISSAN SAFETY BELT 9999 Safety Review #10332222
NISSAN SAFETY BELT 9999 car safety problem was reported on May 23, 2010.NISSAN SAFETY BELT 9999, manufactured by NISSAN NORTH AMERICA, INC. had a problem with CHILD SEAT . 2005 MURANO. RIGHT SIDE PASSENGER SIDE DOOR LOCK BUTTONS ON THE OUTSIDE OF THE DOOR DO NOT WORK AND NOW RARE DOOR LOCK IS DOES NOT LOCK. *TR.Nissan Safety Belt 9999 problem was reported in MINNETONKA, MN. Vehicle was not using Cruise Control. DATE OF MANUFACTURE: 20051127. TYPE OF CHILD SEAT CODE: INFANT. INSTALLATION SYSTEM CODE: LATCH SYSTEM.
Report Your Car Problem Go Top
NISSAN SAFETY BELT Child Seat Shield Assembly
NISSAN SAFETY BELT 9999 Safety Review #10439774
NISSAN SAFETY BELT 9999 car safety problem was reported on Nov 20, 2011.NISSAN SAFETY BELT 9999, manufactured by NISSAN NORTH AMERICA, INC. had a problem with CHILD SEAT:SHIELD ASSEMBLY . (1) I HAVE EXPERIENCED THE SAME PROBLEM WITH THE SEATBELTS IN THE BACK SEAT OF MY 2011 NISSAN TITAN. THEY TIGHTEN UP ON THE OCCUPANTS AND I HAVE TO STOP MY TRUCK IN ORDER TO RELEASE THEM, BUT THEN THEY TIGHTEN UP AGAIN. A SWITCH FOR ADULTS OR CHILDREN MAY FIX THE PROBLEM. (2) AS WELL, THE FRONT FLOOR MATS THAT WERE INSTALLED AT THE DEALER MALFUNCTIONED. THE DRIVER'S FLOOR MAT HAD ONE HOLE FOR RESTRAINT AND IT SHOULD HAVE HAD TWO HOLES. THE FLOOR MAT CAUGHT UP IN THE ACCELERATOR AT A SPEED OF APPROXIMATELY 50 KPH AND THE ENGINE REVVED WIDE OPEN. I HAD TO IMMEDIATELY PUT THE TRUCK IN NEUTRAL AND SHUT IT OFF. THAT LEFT ME WITH NO POWER STEERING AND I WAS FORTUNATE ENOUGH TO GET THE TRUCK TO THE SIDE OF THE HIGHWAY AND REMEDY THE PROBLEM. THE DEALERSHIP HAS SINCE REPLACED THE FRONT FLOOR MATS AND THE PROBEM IS SOLVED. OWNERS OF THE NISSAN TITANS SHOULD MAKE SURE THAT THE PROPER FLOOR MATS ARE INSTALLED IN THEIR TRUCKS PRIOR TO DRIVING THEM. (3) THESE TRUCKS SHOULD NOT BE DELIVERED WITH A P TIRE ON THEM. AT THE VERY LEAST THEY SHOULD HAVE AN LT TIRE. I HAVE HAD THREE FLAT TIRES ON MY TRUCK IN 5 MONTHS AND IT IS NOT USED ON CONSTRUCTION SITES AT ALL. *TR.Nissan Safety Belt 9999 problem was reported in PLUMWESEEP, 00. Vehicle was not using Cruise Control. TYPE OF CHILD SEAT CODE: INFANT. INSTALLATION SYSTEM CODE: VEHICLE SAFETY BELT.
Report Your Car Problem Go Top
NISSAN SAFETY BELT 9999 Safety Review #10474286
NISSAN SAFETY BELT 9999 car safety problem was reported on Sept 07, 2012.NISSAN SAFETY BELT 9999, manufactured by Nissan North America, Inc. had a problem with CHILD SEAT . AIR BAG DEFAULT WARNING ON INSTRUMENT PANEL. 2005 NISSAN ARMADA. DEALER SAYS AIR BAGS WILL NOT WORK UNLESS AN INTERIOR HARNESS FROM AIRBAG/SEAT WEIGHT CUSHION/COMPUTER IS REPLACED. DEALER SAYS THEY HAVE REPLACED "A BUNCH" OF THEM ON NISSAN ARMADAS. COST IS $459 AND AIR BAGS WON'T WORK UNTIL IT IS REPLACED. DEALER SAYS NISSAN DOES NOT HAVE A SAFETY/WARRANTY CAMPAIGN ON THIS FAULTY ITEM. DEALER IS "DOUGLAS NISSAN" IN COLLEGE STATION TX. *TR.Nissan Safety Belt 9999 problem was reported in COLLEGE STATION, TX. Vehicle was not using Cruise Control. TYPE OF CHILD SEAT CODE: INFANT. INSTALLATION SYSTEM CODE: VEHICLE SAFETY BELT.
Report Your Car Problem Go Top
Nissan Safety Belt 9999 systems
Child Seat 3 Review(s)
Child Seat Harness 1 Review(s)
Child Seat Latch Connector 1 Review(s)
Child Seat Retractor 1 Review(s)
Child Seat Shield Assembly 1 Review(s)
Share, Email, Print
Nissan Safety Belt 9999 Reviews
i took my 2005 nissan xterra to a dealership in long beach ca, to have them run a diagnostic test on why my check engine would go off. I drove off having more problems then a had when i took my vehicle into be tested. i paid 1'323.28 for a battery what does it mean when I put my 2004 Nissan Altima in drive and it takes it about 10 or seconds before it will go into drive. The weird thing is I can go into reverse with no problem or lower gear it goes I have a problem with my 2005 Nissan TPMS. After about 10 miles, the reading on the display changes to "**" for 1 of the 4 tires and the low pressure warning light comes on. I've checked pressure on the tires and they are all fine. The dealer t Why my 2008 Nissan maxima flat tire light keep on even we filled air full? i am getting zzon zoon sound from air compressor nissan maxima gxe model1997.what i have to do get its serving or replace the air compressor?please reply. hi would it cause the brakes to lock on if the brake light switch was fitted in the wrong postion on a 4 pin switch nissan tiida?. Crossed jumped my cars battery for 2 sec. Now car will crank but not start 2010 Nissan Frontier Extended Cab and five foot bed vibrates when starting off from a dead stop.....only lasts a second and again only when starting from a dead stop....dealers answer was has an 80,000 mile power train warranty, drive it till it b This is my 2nd quest. I've owned this one over a year. Do the sliding doors not have sensors? My other 05' did. My 1 year old got her fingers caught, thank God it was nothing major, but it could have been. Why would they not have sensors??? This can result in gradual wear over a period of time inside the joint that could lead to the separation of the wiper linkage assembly from the wiper motor linkage at the joint ball. I have a 05 nissan maxima with 35,000 miles. I'm not having a problem at this time. I would like to know if a transgo Kit for the valvebody will help to prevent future problems with the transmission. I have a 01 Niss UD 2600 No Fuel aqt the inj pump but fuel getting to the pump its been very cold and i have changed both filters. i was told there is a crank sensor in the inj. pump where is it?? And How do i check it