Jeep Power Train Clutch Assembly Pedal/linkage
Car-and-Safety.com | JEEP>JEEP Power Train Clutch Assembly Pedal/linkage
Jeep Power Train Clutch Assembly Pedal/linkage Reports
16 Mar
JEEP CHEROKEE 1996 | Clutch Pedal Cut A Wire which connects to the brake lights, thus making brake lights not work. *ak |
JEEP CHEROKEE 1989 | Clutch Pedal Assembly Broke, while driving, to stop vehicle pulled over and shut the engine off. *ak |
JEEP CHEROKEE 1988 | Vehicle Broken Clutch Pedal,omitted welds on clutch pedal. tt |
JEEP CHEROKEE 1992 | Clutch Line Broke While Driving. tt consumer states he was on a climbing grade on the highway towing boat in 3rd gear, |
JEEP CHEROKEE 1993 | Manual Transmission Reverse Gear Is difficult to get into with out a delay.also clutch slave cylinder is defective and needs replacement. |
JEEP WRANGLER 1993 | Vehicle Clutch Assembly Slide Cylinder is leaking and does not operate causing poor and erratic shifting. tt |
JEEP CHEROKEE 1991 | There Is A Gasket In side slave cylinder that is freezing up, upon starting car try to putting it in reverse, car |
JEEP WRANGLER 1991 | The Hydraulic Release Bearing Clutch leaks fluid into the bell housing, making it hard to shift out of a gear. took to |
JEEP COMANCHE 1989 | The Master Clutch Cylinder Hose leaked fluid on the exhaust manifold, causing the vehicle to catch fire. *ak |
JEEP WRANGLER 1997 | Clutch Pedal Fell Off While driving 55 mph. clutch pedal attachment to clutch cylinder has a plastic grommet which broke and caused clutch |
JEEP CHEROKEE 1999 | The Dealer Said They Have seen this problem in many wranglers with the same clutch and transmission. the throw-out bearing has rotated on |
JEEP GRAND CHEROKEE 1999 | Our 1999 Grand Cherokee Has been experiencing a grinding or thumping sound when turning left. this has just started happening in the past 2 |
JEEP WRANGLER 1997 | Exhaust Manifold Cracked 6/21/01, local jeep dealer had no recall, not under warranty. i was in the process of finding a better |
JEEP COMANCHE 1989 | Rubber Clutch Hose Failure. hose is routed too close to exhaust. (3 inches) heat build up in exhaust system melts hose and |
JEEP WRANGLER 1999 | The Throw-out Bearing Clips Broke, which caused the clutch disc and pressure plate to be damaged, hense i had to have all replaced. |
JEEP WRANGLER 2000 | Was Noisy When Purchased They changed the throw out bearing didn't solve problem. *ak |
JEEP WRANGLER 1993 | Clutch Pedal Linkage Detached And clutch went all the way to the floor. clutch was then inoperative and vehicle had to be towed |
JEEP CJ7 1985 | Clutch Linkage Failure. |
JEEP WRANGLER 1995 | Worn Clutch Master Cylinder, causing excess clutch freeplay/rattling of pedal. *ak |
JEEP WRANGLER 1991 | Clutch Assembly: Slave Cylinder Failure. *ak |
JEEP CHEROKEE 1996 | Safety Switch On Clutch Pedal failed. |
JEEP WRANGLER 1994 | Clutch Plate Problem Causes Transmission to grind when shifting into gear. |
JEEP WAGONEER 1984 | Hydraulic Clutch Master Cylinder Is a cast aluminum housing with no steel cylinder liner, causing it too wear out prematurely. *sd |
JEEP CHEROKEE 1989 | Hydraulic Line For Clutch Assembly is too long, causing massive blow-out in rubber hose due to close proximity of rubber hose to exhaust system. |
JEEP WRANGLER 1993 | Slave Cylinder Failed, Causing clutch seals to leak/vehicle to jump when first taking off/poor performance. *skd |
JEEP CHEROKEE 1989 | Clutch Master Cylinder(cmc) Pressure Failed at home; discovered clutch pedal pivot bracket cracked and broken when replacing cmc. discovered only top half of |
JEEP WRANGLER 2006 | Model: 2006 Jeep Wrangler Rubicon with 6 speed transmission. after backing out of a parking stall and during the transition from reverse to |
JEEP WRANGLER 2003 | Service Engine Light. leak in fuel system. *ak |
On This Page
- Select and View Jeep Power Train Clutch Assembly Pedal/linkage Problems
- Discuss Jeep Power Train Clutch Assembly Pedal/linkage Problems
My 1999 Jeep Grand Cherokee looses almost all power steering when moderate to heavy brake pressure is applied, why? please help. i have a problem with my 1995 jeep after i turn of the the power the fuel line keep rune i cant fine the problem ? While driving my 2011 jeep, the check engine light came on and then the traction light and then a signal that has a red thunderbolt on it was present on the dash. I lost power and it began to smoke and flame! The entire front end burned completely i recently disconnected my trailer brake switch, now i have no power to my heater and turn signals can anybody help JEEP LIBERTY 2005 Dec 5, 2011 I had a problem with the car not starting. The dealer says there is a pin that connects the 'ignition switch' to the switch at actually sends power to the stater, the connecting pin is 'broken' and the steering