Chrysler 300 2005 Questions

Car-and-Safety.com



Chrysler 300 2005
Sat, 17 Nov 2012


Chrysler 300 2005 Reviewed by dm on .

did you get your electrical to work? Crysler speedometer, gas ...

did you get your electrical to work? Crysler speedometer, gas gauge, coolent gauge does not work after you start running car ; nobody knows what is wrong

Share, Email, Print

No comments have been provided.

More Chrysler 300 2005 Reports


2006 Chrysler 300, 36,892 miles, dome lights and lights over doors and led mileage came o n after car shut off and doors locked. No other gauges or electrical buttons work. Cannot open trunk or any other item with buttons. Car starts and runs,

I just bought a 2007 Chrysler 300 Touring on 12/11/10. I took it back to the dealership 2 days later because the fromt end shivers a lot when you press on the break. They claim they fixed the problem. Now this car is now parked from 01/28/11, beca

how to install clock spring chrysler 300 touring

I purchased a 2013 Chrysler 300 c 32 months ago and noticed a popping sound as it accelerates up to 40 mpr it will pop at around 20-25 mph then again around 35 -40 mph then whn I am slowing down you can hear it again at same speeds & also down

Chrysler 300 - 2005

symptom - steering all of a sudden goes very tight - is intermittan. could this be a tie rod?

Chrysler 300M 2002 Windshield visibility safety issue. Dashboard glare/reflection on windshield causes poor visibility. Dark colored section of the dash versus light colored section of dash reflect differently causing a  distintive visible line a

I have a 08 chrysler 300 tour limited edition I am having trouble turning the steeering wheel as if it is stuck also it is hard to t

Why do the air bags lite stay on during operation of the vehicle?

all of a sudden i had this strong smell of gas . i parked and turned off the engine. I t disapated, even lifted the hood and couldn't smell it there. then it was alright. and i didn't just get gas either.It seems you have had a problem from hundre

My 1999 chrysler 300m won't start unless I pump the gas pedal really hard and when it starts I have to keep pumping the gas or it will barely run, and then finally die. When I get it to run, and am pumping gas, i hear a loud screeching noise comin

What causes the PCM malfunction on a 99 chrysler 300m?

I purchased brand new 2006 chrysler 300 touring in 5/2005, it now has 80K miles. I have never had a problem until recently when I press the gas it does not want to go, and they it dies without any warning lights, I have taken to dealer says not

The back door latch on my chrysler 300C is stuck and I can't shut the door. How do I get it unstuck? Not the child safety lock, the actual door latch.

my chrysler 300 2003 when stopped or going slow seems like its going to die and sometimes it does and most of the time all of a sudden it accelerates and even sometimes when I'm trying to accelerate it just barely gives any power like if I wasn't

 I have a 2003 Chrysler 300m and my airbag light is on and my horn and cruise control does not work could you please tell me why?

2006 Chrysler 300C -  Gas pedal stuck, I pumped pedal to break it loose and it stuck full throttle at a curve, didn't make curve, took down two brick mail boxes before car stopped, air bag deployed, possibly totaled.

Well I just have to say that I will never purchase another Chrysler product. We brought a 2005 300 HEMI, the horn sounds daily on its own, the airbag lights go on and off, the parking break comes on while driving, the engine knocks loudly. These p

Chrysler 2006 300C ..This car has stalled 3 times since topping off gas tank, Dealer could not see any info on onboard computer. However, they seem to know there is a design problem concernimg gas tank....you are never to top it off as it will sta

i have a 2006 chrysler 300 base... the intrument cluster went out while i was driving...i lost all light...turn signal,brakes,headlight, the complete dash cluster was out an it was buzzing... so i got it fixed $600+ later..then its froze two times

I'm test driving a 2006 Chrysler 300 for the weekend and when I got it home, found out that the floor boards on both driver and passenger side have week spots in them. Does anyone know anything about this?