Subaru Wrx 2014 Service Brakes Review #10561915
SUBARU WRX 2014 car safety problem was reported on Jan 21, 2014.SUBARU WRX 2014, manufactured by Subaru of America, Inc. had a problem with SERVICE BRAKES . in *extremely* cold weather - below of - the vehicle will start successfully however the stability/traction control, anti-lock brakes, and "hill-assist" (part of the abs system) trouble indicator lights will light and stay lit. based on the instruction manual if this occurs, i should cycle the ignition to see if the code clears. this is an unacceptable solution because the car's battery is already extremely stressed due to the cold temperature and may not restart the vehicle. however, on one occurrence i did cycle the ignition and the problem remained. while i recognize that a more vicious brake fluid is needed in a performance vehicle of this type, if the abs pump's orifices were larger this issue might not occur. the other possibility is the brake fluid used during assembly is already supersaturated with moisture and the cold temps allowed the suspended water to fall out of suspension and freeze in the hydraulic lines. vehicle was safe to drive, the brake's mechanical action was unaffected by the fault. the brake and clutch pedals (which i believe to use the same fluid) it did feel like i was pushing through mud. i did confirm the abs was not functional. *tr.0 person(s) were injured. 0 person(s) died.Mileage was 2200 miles. Vehicle Identification Number (VIN):JF1GR7E66EG. Subaru Wrx 2014 problem was reported in STATE COLLEGE, PA. Vehicle was not using ANTI-LOCK BRAKES. Vehicle was not using Cruise Control. Vehicle had 4 CYLINDERS. FUEL TYPE: GAS. VEHICLE SPEED: 0 mph.
Subaru Wrx 2014 Electronic Stability Control Review #10561915
SUBARU WRX 2014 car safety problem was reported on Jan 21, 2014.SUBARU WRX 2014, manufactured by Subaru of America, Inc. had a problem with ELECTRONIC STABILITY CONTROL . in *extremely* cold weather - below of - the vehicle will start successfully however the stability/traction control, anti-lock brakes, and "hill-assist" (part of the abs system) trouble indicator lights will light and stay lit. based on the instruction manual if this occurs, i should cycle the ignition to see if the code clears. this is an unacceptable solution because the car's battery is already extremely stressed due to the cold temperature and may not restart the vehicle. however, on one occurrence i did cycle the ignition and the problem remained. while i recognize that a more vicious brake fluid is needed in a performance vehicle of this type, if the abs pump's orifices were larger this issue might not occur. the other possibility is the brake fluid used during assembly is already supersaturated with moisture and the cold temps allowed the suspended water to fall out of suspension and freeze in the hydraulic lines. vehicle was safe to drive, the brake's mechanical action was unaffected by the fault. the brake and clutch pedals (which i believe to use the same fluid) it did feel like i was pushing through mud. i did confirm the abs was not functional. *tr.0 person(s) were injured. 0 person(s) died.Mileage was 2200 miles. Vehicle Identification Number (VIN):JF1GR7E66EG. Subaru Wrx 2014 problem was reported in STATE COLLEGE, PA. Vehicle was not using ANTI-LOCK BRAKES. Vehicle was not using Cruise Control. Vehicle had 4 CYLINDERS. FUEL TYPE: GAS. VEHICLE SPEED: 0 mph.
Subaru Wrx 2014 Vehicle Speed Control Review #10561915
SUBARU WRX 2014 car safety problem was reported on Jan 21, 2014.SUBARU WRX 2014, manufactured by Subaru of America, Inc. had a problem with VEHICLE SPEED CONTROL . in *extremely* cold weather - below of - the vehicle will start successfully however the stability/traction control, anti-lock brakes, and "hill-assist" (part of the abs system) trouble indicator lights will light and stay lit. based on the instruction manual if this occurs, i should cycle the ignition to see if the code clears. this is an unacceptable solution because the car's battery is already extremely stressed due to the cold temperature and may not restart the vehicle. however, on one occurrence i did cycle the ignition and the problem remained. while i recognize that a more vicious brake fluid is needed in a performance vehicle of this type, if the abs pump's orifices were larger this issue might not occur. the other possibility is the brake fluid used during assembly is already supersaturated with moisture and the cold temps allowed the suspended water to fall out of suspension and freeze in the hydraulic lines. vehicle was safe to drive, the brake's mechanical action was unaffected by the fault. the brake and clutch pedals (which i believe to use the same fluid) it did feel like i was pushing through mud. i did confirm the abs was not functional. *tr.0 person(s) were injured. 0 person(s) died.Mileage was 2200 miles. Vehicle Identification Number (VIN):JF1GR7E66EG. Subaru Wrx 2014 problem was reported in STATE COLLEGE, PA. Vehicle was not using ANTI-LOCK BRAKES. Vehicle was not using Cruise Control. Vehicle had 4 CYLINDERS. FUEL TYPE: GAS. VEHICLE SPEED: 0 mph.
Subaru Wrx 2014 Service Brakes Review #10616858
SUBARU WRX 2014 car safety problem was reported on June 23, 2014.SUBARU WRX 2014, manufactured by Subaru of America, Inc. had a problem with SERVICE BRAKES . tl* the contact owns a 2014 subaru wrx. the contact stated that while driving in stop and go traffic, the brakes failed to respond. the vehicle was taken to a independent mechanic, who repaired the vehicle. the contact was unaware of the exact repairs made to the vehicle. the manufacturer was contacted about the failure. the approximate failure mileage was unknown..0 person(s) were injured. 0 person(s) died.Vehicle Identification Number (VIN):JF1GV7F65EG. Subaru Wrx 2014 problem was reported in MILLTOWN, NJ. Vehicle was not using ANTI-LOCK BRAKES. Vehicle was not using Cruise Control.