Recalls for CROWN VICTORIA FORD, FORD MOTOR COMPANY, SEATS:FRONT ASSEMBLY:POWER ADJUST, Nov 23, 1993

A recall was issued on Nov 23, 1993 for CROWN VICTORIA FORD, manufactured by FORD MOTOR COMPANY, in response to SEATS:FRONT ASSEMBLY:POWER ADJUST problems. AN UNUSED POWER SEAT HARNESS CONNECTOR IS POSITIONED ON THE RUBBER FLOOR MAT UNDER THE SEAT. IF THE VEHICLE IS OPERATED IN COLD WEATHER IN AREAS THAT HAVE LARGE AMOUNTS OF SALT USED FOR SNOW AND ICE CONTROL, A PUDDLE OF SALTWATER CAN ACCUMULATE ON THE RUBBER FLOOR MATS, REPEATEDLY WETTING THE CONNECTOR. THIS WILL RESULT IN CORROSION OF THE CONNECTOR, CAUSING A CURRENT TO FLOW BETWEEN THE TERMINALS WITHOUT TRIPPING THE CIRCUIT BREAKER.IF THIS OCCURS, CURRENT FLOW CAN HEAT THE CONNECTOR ANDRELEASE FUMES INTO THE PASSENGER COMPARTMENT, AND CAN RESULT IN A VEHICLE FIRE.. Follwoing is the summary of corrective actions taken: DEALERS WILL REMOVE THE UNUSED CONNECTOR AND INSTALL A SEALED HEAT SHRINK CAP OVER THE AFFECTED WIRES.
SYSTEM: INTERIOR SYSTEMS; TRACKS AND ANCHORS; FRONT SEAT; POWER.VEHICLE DESCRIPTION: POLICE/FLEET VEHICLES EQUIPPED WITH RUBBER FLOOR MATS ANDNON-POWERED FRONT SEATS.NOTE: IF YOUR VEHICLE IS PRESENTED TO AN AUTHORIZED DEALER ON AN AGREED UPONSERVICE DATE AND THE REMEDY IS NOT PROVIDED WITHIN A REASONABLE TIME AND FREEOF CHARGE OR THE REMEDY DOES NOT CORRECT THE DEFECT OR NONCOMPLIANCE, PLEASECONTACT FORD SERVICE CENTER AT 1-800-392-3673. ALSO, CONTACT THE NATIONALHIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-800-424-9393.