Car-and-Safety.com

Pontiac Vibe Structure Body Door Safety Report | July 30, 2004



Reported on July 30, 2004


2004 PONTIAC VIBE THE RUBBER STRIPING AND MOLDING ON THE DRIVER'S DOOR KEEPS SPLITTING AND WEARING OUT EVERY 3500 MILES. ALSO THERE ARE 2 SPOTS ON THE INSIDE OF THE DOOR WHERE THE PAINT IS GONE IN 2 EXACT ROUND SPOTS FROM THE DOOR VIBRATING. I WAS TOLD BY SOMEONE OTHER THEN THE DEALER THAT HIS COULD BE CAUSED BY ONE OF TWO THINGS. EITHER THE BODY IS FLEXING OR THERE IS A WELD MISSING ON THE UNIBODY. THE FLEXING WOULD BE BECAUSE OF THE SUNROOF. THEY (THE FACTORY) REMOVES A BEAM TO PUT THE SUNROOF IN AND THIS CAUSES A STRUCTURE PROBLEM WHICH IS CAUSING THE POSSIBLE FLEXING. THE DEALER REPLACED THE MOLDING ONCE AND GM IS REFUSING TO REPLACE IT GAIN. THEY HAD AN ENGINEER PUT THE VEHICLE ON A FRAME MACHINE TO SEE IF IT IS STRAIGHT. I HAVE BEEN ADVISED THAT THIS IS A SAFETY AND DEFECT ISSUE AND SHOULD BE EXTREMELY CAREFUL DRIVING THIS VEHICLE. *AK
Make: Pontiac
Model: Vibe
Manufactured by: GENERAL MOTORS CORP.
Year: 2004
Was a crash reported? N
Was an injury reported? 0 person(s) were injured.
Was a death reported? 0 person(s) died.
Was a fire reported? N
Location: VOORHEESVILLE NY
Vehicle Identification Number (VIN): 5Y2SL62844Z
Mileage: 3500 miles.
Speed: 0 MPH
Number of cylinders: 4
Vehicle type: FWD
Vehicle fuel: GAS Fuel injection.
Was a police report filed? N
Tire size:
Dealer name and location: WEDEKIND PONTIAC SCHENECTADY NY 12304
Previous Report:Structure Body Door Next Report:Air Bags Frontal Sensor/control Module

Join Pontiac safety problem discussion



Share, Email, Print