Car-and-Safety.com

Plymouth Grand Voyager 1986 Safety Reports and Reviews



Plymouth Grand Voyager Reports


PLYMOUTH GRAND VOYAGER Engine And Engine Cooling Engine

PLYMOUTH GRAND VOYAGER 1986 Engine And Engine Cooling Engine Report #8001801

PLYMOUTH GRAND VOYAGER 1986 car safety problem was reported on Dec 24, 2001.PLYMOUTH GRAND VOYAGER 1986, manufactured by DAIMLERCHRYSLER CORPORATION had a problem with ENGINE AND ENGINE COOLING:ENGINE . VEHICLE WAS PARKED INSIDE OF GARAGE. HE WENT TO MOVE VEHICLE BY BACKING OUT FROM GARAGE, AND NOTICED THAT OIL WAS LEAKING FROM UNDERNEATH THE VEHICLE. DEALERSHIP WAS AWARE OF PROBLEM.*AK.Vehicle Identification Number (VIN):1P4GP44R4TB. Plymouth Grand Voyager 1986 problem was reported in CARSON, CA. Vehicle was not using Cruise Control.
     Report Your Car Problem      Go Top

Plymouth Grand Voyager 1986 systems


Share, Email, Print



Take a survey



Plymouth Grand Voyager 1986 Reviews


how do i fix the water pump with out taking everything apart

I have a 1991 Plymouth Grand Voyager. Recently I've noticed that the steering wheel sometimes shakes while I'm driving....not severe, but it's very disconcerting. Also, I am hearing noise from the front passenger side. I checked the tire pressu

1999 plymouht voyager  3.3 at remplace the rack and pinnion  and front strut and noise coking comming over time

what does it mean when the car still turns on but wont move in any gear and also rolls in park?

where is the speed sensor on a plymouth aclame

where on the 1998 plymouth voyager se would i find the rear defrost wiring.

transmission is controlled by electric servos, not line pressure. Servo package may be bad (silver box on trans case) or your fluid is low, or your transmission filter is clogged. Filter and fluid are under 20 bucks. Servo pack is much more. 

You cannot bleed brakes through an ABS system. You have to get it professionally done with the proper tools. 

The spark is controlled by 2 sensors, crank and camshaft. Either not working will cause a no spark situation. The camshaft sensor is the main sensor, but if the crank sensor doesnt "see" crankshaft rotation, it assumes the car has been turned off

You dont. The pump is under the pulley cover on both 4 and 6 motors, and the cover is around the motor mount. You also need to remove the crank hub to get the cover off, and that involves a crankshaft pulley puller, removing the inner fenderwell o

While driving my 1999 plymouth breeze the car went into low gear and the speedmetor stop working

95 grand voyager in limp mode...replaced input and output speed sensors, correct fluid, still in limp mode. Please help!!


Discuss PLYMOUTH GRAND VOYAGER 1986


No comments have been provided.