Car-and-Safety.com

Plymouth Fury 1989 Safety Reports and Reviews



Plymouth Fury Reports


PLYMOUTH FURY Steering Linkages Tie Rod Assembly

PLYMOUTH FURY 1989 Steering Linkages Tie Rod Assembly Report #964828

PLYMOUTH FURY 1989 car safety problem was reported on Apr 29, 1995.PLYMOUTH FURY 1989, manufactured by DAIMLERCHRYSLER CORPORATION had a problem with STEERING:LINKAGES:TIE ROD ASSEMBLY . DRIVING ON A LOCAL ROAD AT 20 MPH WHEN TIE ROD END BROKE AND VEHICLE PULLED TO THE RIGHT AND HIT A WALL. TT.Vehicle was involved in a crash. 1 person(s) were injured. 0 person(s) died.Vehicle Identification Number (VIN):1P3XM2641KW. Plymouth Fury 1989 problem was reported in BROOKLYN, NY. Vehicle was not using Cruise Control.
     Report Your Car Problem      Go Top

Plymouth Fury 1989 systems


Share, Email, Print



Rate PLYMOUTH FURY 1989 Reliability


Excellent
Good
OK
Bad
Terrible

View Results

Do you enjoy driving your car?


Great, love it!
Yes, a very good ride
It is OK...
No, Don't like it
Definitely Not, Terrible

View Results

You might be interested in the following information from our sponsors



Plymouth Fury 1989 Reviews


how do i fix the water pump with out taking everything apart

I have a 1991 Plymouth Grand Voyager. Recently I've noticed that the steering wheel sometimes shakes while I'm driving....not severe, but it's very disconcerting. Also, I am hearing noise from the front passenger side. I checked the tire pressu

1999 plymouht voyager  3.3 at remplace the rack and pinnion  and front strut and noise coking comming over time

what does it mean when the car still turns on but wont move in any gear and also rolls in park?

where is the speed sensor on a plymouth aclame

where on the 1998 plymouth voyager se would i find the rear defrost wiring.

transmission is controlled by electric servos, not line pressure. Servo package may be bad (silver box on trans case) or your fluid is low, or your transmission filter is clogged. Filter and fluid are under 20 bucks. Servo pack is much more. 

You cannot bleed brakes through an ABS system. You have to get it professionally done with the proper tools. 

The spark is controlled by 2 sensors, crank and camshaft. Either not working will cause a no spark situation. The camshaft sensor is the main sensor, but if the crank sensor doesnt "see" crankshaft rotation, it assumes the car has been turned off

You dont. The pump is under the pulley cover on both 4 and 6 motors, and the cover is around the motor mount. You also need to remove the crank hub to get the cover off, and that involves a crankshaft pulley puller, removing the inner fenderwell o

While driving my 1999 plymouth breeze the car went into low gear and the speedmetor stop working

95 grand voyager in limp mode...replaced input and output speed sensors, correct fluid, still in limp mode. Please help!!


Discuss PLYMOUTH FURY 1989


No comments have been provided.


Plymouth Fury 1989 Service Bulletins

PLYMOUTH FURY 1989