Jeep Suspension Front Control Arm Lower Arm
Car-and-Safety.com | JEEP>JEEP Suspension Front Control Arm Lower Arm
Jeep Suspension Front Control Arm Lower Arm Reports
16 Mar
JEEP GRAND CHEROKEE 1996 | When Applying The Brakes The bracket that supports the front right lower control arm to the front axle broke in the middle, |
JEEP WRANGLER 1997 | While Making A Right Turn at 35 mph vehicle pulled to the right. mechanic determined right and left lower control arms were bent, |
JEEP CHEROKEE 2001 | The Vehicle Front End Was vibrating, due to the upper and lower control arms being faulty.*yh |
JEEP GRAND CHEROKEE 1994 | Upper And Lower Control Arms failed causing extreme vibration. |
JEEP PATRIOT 4X4 2007 | Tl* The Contact Owns A 2007 jeep patriot 4x4. the contact stated that the vehicle was being examined by an authorized dealer for routine |
JEEP PATRIOT 4X4 2008 | Tl* The Contact Owns A 2008 jeep patriot 4x4. while driving approximately 65 mph, the vehicle began to pull toward the right. |
JEEP PATRIOT 4X4 2007 | Tl* The Contact Owns A 2007 jeep patriot 4x4. the vehicle was with the dealer for routine maintenance when the technician advised that contact |
JEEP LIBERTY 4X4 2008 | Left Lower Control Arm Replaced. *kb |
JEEP COMPASS 2009 | Tl*the Contact Owns A 2009 jeep compass. the contact was driving approximately 45 mph when the front lower control arm failed. in addition, |
JEEP LIBERTY 2005 | Tl*the Contact Owns A 2005 jeep liberty. while driving 35 mph, the ball joints separated when she depressed the brakes. |
JEEP LIBERTY 2002 | Tl*the Contact Owns A 2002 jeep liberty. he stated that he received a recall notice (nhtsa campaign # 03v460000) for the lower ball |
JEEP LIBERTY 2005 | Tl*the Contact Owns A 2005 jeep liberty. while driving 15 mph, the vehicle's rear lower control arm split in half. |
JEEP GRAND CHEROKEE 2005 | When Driving In My Neighborhood which is a 25 mph zone i applied brakes lightly after just coming out of a turn. at this |
JEEP LIBERTY 2004 | Dt*: The Contact Stated When a nhtsa recall letter # f23, for the suspension: front: control arm: lower ball joint was received; the |
JEEP LIBERTY 2002 | Dt*: The Contact Stated Having problems with the brakes. the problem started after the vehicle was repaired at the dealership, for a |
JEEP LIBERTY 2002 | Dt*: The Contact Stated while driving 45 mph on normal road conditions the vehicle pulled hard to the right. prior the incident |
JEEP LIBERTY 2004 | Vehicle Was Diagnosed After Only 50k miles that ball joints and sway bar was "bad". vehicle was in reverse, going |
JEEP GRAND CHEROKEE 1994 | Dt*: The Contact Stated while having the brakes replaced, the technician found a broken weld. the vehicle was taken to an |
JEEP LIBERTY 2002 | Dt: The Contact Stated while driving on a curve the lower control arm snapped, and he could not control the vehicle. |
JEEP CHEROKEE 1993 | Dt: Consumer's Daughter Was Driving through walmart parking lot at a low speed and heard a loud noise coming from the front end of the |
JEEP LIBERTY 2002 | Since Purchasing This 2002 Jeep liberty for my 23 year old daughter it has pulled to the left when the steering wheel was released. |
JEEP LIBERTY 2002 | Lower Control Arm Bolt On front passenger side broke off, causing lower control arm to come loose during low speed travel travel, causing |
On This Page
- Select and View Jeep Suspension Front Control Arm Lower Arm Problems
- Discuss Jeep Suspension Front Control Arm Lower Arm Problems
Witch way does flywheel face on 03 jeep liberty Automatic transmission My 1999 Jeep Grand Cherokee looses almost all power steering when moderate to heavy brake pressure is applied, why? please help. I have a 2008 Jeep Compass, front wheel drive with 40,000 miles on it. I just dropped it off at my mechanics this morning needing my second ball joint. I had the left front one done a couple months ago, this is the right one. This is unheard i have a problem with my 1995 jeep after i turn of the the power the fuel line keep rune i cant fine the problem ?
P740 code at 82,000 miles on a 2005 jeep liberty. Change complete valve body assembly (including TCC soleniod) trans temp sensor still comes on when in overdrive, now needs a Torque converter because it is breaking down