Car-and-Safety.com
Gmc Canyon 2010 Safety Reports and Reviews
Gmc Canyon Reports
GMC CANYON Structure
GMC CANYON 2010 Safety Review #10362222
GMC CANYON 2010 car safety problem was reported on Sept 23, 2010.GMC CANYON 2010, manufactured by GENERAL MOTORS CORP. had a problem with STRUCTURE . TL*THE CONTACT OWNS A 2010 GMC CANYON. THE CONTACT NOTICED THAT THE VEHICLE DID NOT HAVE A SKID PLATE INSTALLED ON THE UNDERCARRIAGE THAT WOULD PROTECT THE FRONT DIFFERENTIAL AND TRANSFER CASE. THE VEHICLE WAS TAKEN TO AN AUTHORIZED DEALER WHERE HE WAS INFORMED THAT ALL OF THE VEHICLES WERE MANUFACTURED WITHOUT THE SKID PLATE. THE VEHICLE HAD NOT BEEN REPAIRED. THE FAILURE MILEAGE WAS 0 AND THE CURRENT MILEAGE WAS 350..Mileage was 0 miles. Vehicle Identification Number (VIN):1GTKTCDE8A8. Gmc Canyon 2010 problem was reported in ARKADELPHIA, AR. Vehicle was not using ANTI-LOCK BRAKES. Vehicle was not using Cruise Control. VEHICLE SPEED: 0 mph.
Report Your Car Problem Go Top
GMC CANYON Vehicle Speed Control
GMC CANYON 2010 Safety Review #10383373
GMC CANYON 2010 car safety problem was reported on Feb 07, 2011.GMC CANYON 2010, manufactured by GENERAL MOTORS LLC had a problem with VEHICLE SPEED CONTROL . GMC 2010 CANYON ROLLS FORWARD UP HILL AT 5MPH IDLING WITH FOOT OF GAS AND GMC CAN'T LOWER THE IDLING RPM I HAVE TO SHIFT TO N. TO STOP THE TRUCK MOVING FORWARD. *TR.Mileage was 4011 miles. Vehicle Identification Number (VIN):1GTESCD94A8. Gmc Canyon 2010 problem was reported in CLERMONT, FL. Vehicle was not using ANTI-LOCK BRAKES. Vehicle was not using Cruise Control. Vehicle had 4 CYLINDERS. Gmc Canyon 2010 drive type:RWD. VEHICLE SPEED: 5 mph.
Report Your Car Problem Go Top
GMC CANYON Suspension
GMC CANYON 2010 Safety Review #10405651
GMC CANYON 2010 car safety problem was reported on Oct 05, 2010.GMC CANYON 2010, manufactured by GENERAL MOTORS LLC had a problem with SUSPENSION . TL* THE CONTACT OWNS A 2010 GMC CANYON. THE CONTACT STATED THAT WHEN DRIVING AT HIGHWAY SPEEDS, HE NOTICED THAT THE FRONT END WOULD SHAKE VIOLENTLY. THE VEHICLE WAS INSPECTED BY A DEALER AND THEY ADVISED HIM THAT EVERY BOLT IN THE FRONT END WAS LOOSE. THE VEHICLE WAS REPAIRED BY TIGHTENING ALL THE BOLTS. THE FAILURE RECURRED CONTINUOUSLY FOR APPROXIMATELY FOUR MONTHS. THE MANUFACTURER WAS CONTACTED AND THEY OFFERED NO ASSISTANCE. THE FAILURE MILEAGE WAS APPROXIMATELY 12,000. THE VIN WAS UNAVAILABLE. UPDATED 07/20/11 *BF .Mileage was 12000 miles. Vehicle Identification Number (VIN):1GTDSCD93A8. Gmc Canyon 2010 problem was reported in IRON CITY, TN. Vehicle was not using ANTI-LOCK BRAKES. Vehicle was not using Cruise Control. VEHICLE SPEED: 20 mph.
Report Your Car Problem Go Top
GMC CANYON Electrical System Instrument Panel
GMC CANYON 2010 Safety Review #10419413
GMC CANYON 2010 car safety problem was reported on Aug 04, 2011.GMC CANYON 2010, manufactured by GENERAL MOTORS LLC had a problem with ELECTRICAL SYSTEM: INSTRUMENT PANEL . THERE WAS A RANDOM FAILURE OF SPEEDOMETER TO REGISTER CORRECT SPEED. I AM NEW TO THIS VEHICLE SO I DO NOT KNOW HOW OFTEN IT HAS HAPPENED. I HAVE READ THAT THIS IS A COMMON PROBLEM BUT HAVE NOT YET TAKEN IT TO THE DEALER. *TR.Mileage was 7000 miles. Vehicle Identification Number (VIN):1GTESCD90A8. Gmc Canyon 2010 problem was reported in TUSCALOOSA, AL. Vehicle was not using ANTI-LOCK BRAKES. Vehicle was not using Cruise Control.
Report Your Car Problem Go Top
GMC CANYON Vehicle Speed Control
GMC CANYON 2010 Safety Review #10427193
GMC CANYON 2010 car safety problem was reported on July 22, 2011.GMC CANYON 2010, manufactured by GENERAL MOTORS LLC had a problem with VEHICLE SPEED CONTROL . TL* THE CONTACT OWNS A 2010 GMC CANYON. THE CONTACT STATED THAT THE ACCELERATOR PEDAL BECAME STUCK WHEN DEPRESSED. THE CONTACT WAS UNABLE TO MAINTAIN CONTROL OF THE VEHICLE AND CRASHED INTO A THREE INCH PIPE RAIL. THERE WERE NO INJURIES AND A POLICE REPORT WAS NOT FILED. THE MANUFACTURER WAS NOTIFIED AND AN INVESTIGATION WAS OPENED FOR THE DEFECT. THE DEALER WAS CONTACTED BUT DENIED ANY ASSISTANCE WITH REPAIRS TO THE FAILURE. THE VEHICLE WAS REPAIRED. THE FAILURE MILEAGE WAS 5,982 AND THE CURRENT MILEAGE WAS 6,182. .Vehicle was involved in a crash. Mileage was 5982 miles. Vehicle Identification Number (VIN):1GTJTCDE1A8. Gmc Canyon 2010 problem was reported in DAVIS JUNCTION, IL. Vehicle was not using ANTI-LOCK BRAKES. Vehicle was not using Cruise Control.
Report Your Car Problem Go Top
GMC CANYON Power Train
GMC CANYON 2010 Safety Review #10479551
GMC CANYON 2010 car safety problem was reported on Aug 15, 2012.GMC CANYON 2010, manufactured by General Motors LLC had a problem with POWER TRAIN . TL* THE CONTACT OWNS A 2010 GMC CANYON. THE CONTACT STATED THAT WHEN PLACING THE GEAR IN FOUR WHEEL DRIVE THE CONTACT NOTICED A VIBRATION AND A LOUD BANGING SOUND IN THE FRONT END OF THE VEHICLE. THE VEHICLE WAS TAKEN TO THE DEALER WHO STATED THAT THERE WAS NO KNOWN REMEDY FOR THE FAILURE AND STATED THAT THE VEHICLE WAS IN NORMAL OPERATING CONDITION. THE VEHICLE WAS NOT REPAIRED. THE APPROXIMATE FAILURE MILEAGE WAS 10,000. .0 person(s) were injured. 0 person(s) died.Mileage was 10000 miles. Vehicle Identification Number (VIN):1GTJTCDE8A8. Gmc Canyon 2010 problem was reported in SHELBY TOWNSHIP, MI. Vehicle was not using ANTI-LOCK BRAKES. Vehicle was not using Cruise Control. VEHICLE SPEED: 0 mph.
Report Your Car Problem Go Top
GMC CANYON Fuel System, Gasoline
GMC CANYON 2010 Safety Review #10479796
GMC CANYON 2010 car safety problem was reported on Sept 24, 2012.GMC CANYON 2010, manufactured by General Motors LLC had a problem with FUEL SYSTEM, GASOLINE . TL* THE CONTACT OWNS A 2010 GMC CANYON. THE CONTACT STATED THAT WHILE DRIVING 10 MPH IN RAINY WEATHER, THE VEHICLE STALLED WITH THE ILLUMINATION OF THE CHECK ENGINE WARNING LIGHT. THE VEHICLE WAS TAKEN TO THE DEALER FOR INSPECTION WHERE THEY ADVISED THAT THE FUEL PUMP MODULE NEEDED TO BE REPLACED. IN ADDITION, THE CONTACT WAS ADVISED THAT HIS VEHICLE WAS NOT INCLUDED IN NHTSA CAMPAIGN ID NUMBER: 09V154000 (FUEL SYSTEM, GASOLINE). THE VEHICLE WAS REPAIRED. THE MANUFACTURER WAS NOTIFIED AND THEY STATED THAT SAME THING. THE FAILURE MILEAGE WAS 39,104. ..UPDATED 12/11/12 *BF THE CONSUMER STATED THE VEHICLE STALLED AGAIN AFTER IT WAS REPAIRED. THE DEALER FOUND CORROSION ON THE WIRE HARNESS. UPDATED 12/12/12.0 person(s) were injured. 0 person(s) died.Mileage was 39104 miles. Vehicle Identification Number (VIN):1GTJTCDE2A8. Gmc Canyon 2010 problem was reported in WEST HARRISON, NY. Vehicle was purchased on 20100915. Vehicle was using ANTI-LOCK BRAKES.Vehicle was using Cruise Control.Vehicle had 5 CYLINDERS. Gmc Canyon 2010 drive type:4WD. FUEL SYSTEM:Fuel injection. FUEL TYPE: GAS. Gmc Canyon 2010 TRANSMISSION TYPE: AUTO. VEHICLE SPEED: 60 mph. DEALER'S NAME: WHITE PLAINS GMC .
Report Your Car Problem Go Top
GMC CANYON Electrical System Wiring
GMC CANYON 2010 Safety Review #10479796
GMC CANYON 2010 car safety problem was reported on Sept 24, 2012.GMC CANYON 2010, manufactured by General Motors LLC had a problem with ELECTRICAL SYSTEM:WIRING . TL* THE CONTACT OWNS A 2010 GMC CANYON. THE CONTACT STATED THAT WHILE DRIVING 10 MPH IN RAINY WEATHER, THE VEHICLE STALLED WITH THE ILLUMINATION OF THE CHECK ENGINE WARNING LIGHT. THE VEHICLE WAS TAKEN TO THE DEALER FOR INSPECTION WHERE THEY ADVISED THAT THE FUEL PUMP MODULE NEEDED TO BE REPLACED. IN ADDITION, THE CONTACT WAS ADVISED THAT HIS VEHICLE WAS NOT INCLUDED IN NHTSA CAMPAIGN ID NUMBER: 09V154000 (FUEL SYSTEM, GASOLINE). THE VEHICLE WAS REPAIRED. THE MANUFACTURER WAS NOTIFIED AND THEY STATED THAT SAME THING. THE FAILURE MILEAGE WAS 39,104. ..UPDATED 12/11/12 *BF THE CONSUMER STATED THE VEHICLE STALLED AGAIN AFTER IT WAS REPAIRED. THE DEALER FOUND CORROSION ON THE WIRE HARNESS. UPDATED 12/12/12.0 person(s) were injured. 0 person(s) died.Mileage was 39104 miles. Vehicle Identification Number (VIN):1GTJTCDE2A8. Gmc Canyon 2010 problem was reported in WEST HARRISON, NY. Vehicle was purchased on 20100915. Vehicle was using ANTI-LOCK BRAKES.Vehicle was using Cruise Control.Vehicle had 5 CYLINDERS. Gmc Canyon 2010 drive type:4WD. FUEL SYSTEM:Fuel injection. FUEL TYPE: GAS. Gmc Canyon 2010 TRANSMISSION TYPE: AUTO. VEHICLE SPEED: 60 mph. DEALER'S NAME: WHITE PLAINS GMC .
Report Your Car Problem Go Top
Gmc Canyon 2010 systems
Electrical System Instrument Panel 1 Review(s)
Electrical System Wiring 1 Review(s)
Fuel System, Gasoline 1 Review(s)
Power Train 1 Review(s)
Structure 1 Review(s)
Suspension 1 Review(s)
Vehicle Speed Control 2 Review(s)
Share, Email, Print
Gmc Canyon 2010 Reviews
My GMC K1500 sometimes starts running rough. It may correct it's self or may continue running rough untill you turn it off for a while then start it up again. Sometimes it may go a month with no problem then the problem may come right back. 1998 GMC Sierra 4x4. 118,000 miles but rebuilt engine installed at 78,000 miles. Drive carefully, slow take offs, 65 to 70 mph on road, but gas mileage is 10 to 11.5 mpg. Changed air filter but no better. Tire pressure is fine. Any suggestions for 2004 GMC Envoy~~~ I have no rt or lft brake lights.(only the bar brake light at the top of the hatch.) I was told that the right one wasn't working. When I went under the seat to check the fuse I noticed that it was the only fuse that was loose, j What can i do to repair the problem i have with my wipers being intermittend thank you. I have a 2007 Yukon Denali XL and my climate control + button for the heat on the drivers side peeled off. Anyone out there having the same issue? It looks like the passengers side is doing the same. Seat belt will not retract on 2004 GMC ENVOY XLT Seat belt will not retract on 2004 GMC ENVOY XLT It is stuck all pulled out and will not roll back up. rear end is splipping 2005 GMC W-5500 has low power starting at 40 mph or going up a hill? 2003 envoy sle 4wd - service 4wd light , parking brake , abs lights on plus hvac fan does not work BUT no codes on any .and also stalls out at idle . what the heck is going on. help! abs activation at low speeds on a 2002 yukon with a 5.3 L engine. The abs activates at 10 km/h. blower speed switch burns up as soon as you turn it on,wipers hang up and stay on when switch is turned off
IT is stuck all pulled out , and will not rolll back in .
any idea on how to fix this .