Dodge Wagon 1995 Seats Front Assembly Recliner Review #550971
DODGE WAGON 1995 car safety problem was reported on Dec 01, 1999.DODGE WAGON 1995, manufactured by DAIMLERCHRYSLER CORPORATION had a problem with SEATS:FRONT ASSEMBLY:RECLINER . seat latch failed causing the front driver seat back to break. nlm .Vehicle Identification Number (VIN):2B4GH4538SR. Dodge Wagon 1995 problem was reported in WHEATON, MD. Original Owner. Vehicle was using ANTI-LOCK BRAKES.Vehicle was using Cruise Control.Dodge Wagon 1995 drive type:FWD. FUEL SYSTEM:N/A. FUEL TYPE: GAS. Dodge Wagon 1995 TRANSMISSION TYPE: AUTO.
Dodge Wagon 1995 Power Train Driveline Differential Unit Review #762630
DODGE WAGON 1995 car safety problem was reported on Aug 01, 2000.DODGE WAGON 1995, manufactured by DAIMLERCHRYSLER CORPORATION had a problem with POWER TRAIN:DRIVELINE:DIFFERENTIAL UNIT . in august of 2000 my wife and i took a trip utilizing this van to pull our travel trailer out to the east coast, (maine). prior to departure all fluid levels where checked and adjusted. when stopping for fuel in vermont i noticed (smelled) the odor of hot gear grease. upon inspection i discovered that oil was being blown out past the pinion seal. i proceeded to refill the differential and continued on our trip checking the fluid prior to each leg of our trip. upon arriving home from our trip i purchased a new seal from our local chrysler dealer and replaced leaking pinion seal. this vehicle (and the trailer that it tows) are stored inside all winter. in getting the vehicle ready for a trip in may of 2002 i observed that the abs light was on and in diagnosing the problem with the abs system identified that the pinion seal is leaking gear oil again. the abs sensor on the differential had failed, i believe, from the excessive heat of the rear axel. in researching what the cause of the pinion seal could be i have identified that chrysler or its subcontractor during the manufacturing of the axel housing failed to place a vent in either the axel tube or the differential housing allowing the pressure from the hot oil to push the oil out of the housing past the pinion seal. in talking to other dodge owners i have been told that they had a problem with the differential fill plug (plastic) being blown out from the pressure thereby allowing the oil to leak. i suspect that the way the differential now sings and by the blueing of the metal that it is headed for failure in the very near future. hopefully you can convince dodge to do a recall and install vents on the axel tubes of those trucks that haven't yet had an overheating problem, and to also take care of those customers that have had a problem. thank you for your time. *ak.Vehicle Identification Number (VIN):2B4HB25Z6SK. Dodge Wagon 1995 problem was reported in ALPENA, MI. Original Owner. Vehicle was purchased on Dec 01, 2094. Vehicle was using ANTI-LOCK BRAKES.Vehicle was using Cruise Control.Dodge Wagon 1995 drive type:RWD. FUEL SYSTEM:N/A. FUEL TYPE: GAS.
Dodge Wagon 1995 Power Train Driveline Differential Unit Review #762630
DODGE WAGON 1995 car safety problem was reported on Aug 01, 2000.DODGE WAGON 1995, manufactured by DAIMLERCHRYSLER CORPORATION had a problem with POWER TRAIN:DRIVELINE:DIFFERENTIAL UNIT . in august of 2000 my wife and i took a trip utilizing this van to pull our travel trailer out to the east coast, (maine). prior to departure all fluid levels where checked and adjusted. when stopping for fuel in vermont i noticed (smelled) the odor of hot gear grease. upon inspection i discovered that oil was being blown out past the pinion seal. i proceeded to refill the differential and continued on our trip checking the fluid prior to each leg of our trip. upon arriving home from our trip i purchased a new seal from our local chrysler dealer and replaced leaking pinion seal. this vehicle (and the trailer that it tows) are stored inside all winter. in getting the vehicle ready for a trip in may of 2002 i observed that the abs light was on and in diagnosing the problem with the abs system identified that the pinion seal is leaking gear oil again. the abs sensor on the differential had failed, i believe, from the excessive heat of the rear axel. in researching what the cause of the pinion seal could be i have identified that chrysler or its subcontractor during the manufacturing of the axel housing failed to place a vent in either the axel tube or the differential housing allowing the pressure from the hot oil to push the oil out of the housing past the pinion seal. in talking to other dodge owners i have been told that they had a problem with the differential fill plug (plastic) being blown out from the pressure thereby allowing the oil to leak. i suspect that the way the differential now sings and by the blueing of the metal that it is headed for failure in the very near future. hopefully you can convince dodge to do a recall and install vents on the axel tubes of those trucks that haven't yet had an overheating problem, and to also take care of those customers that have had a problem. thank you for your time. *ak.Vehicle Identification Number (VIN):2B4HB25Z6SK. Dodge Wagon 1995 problem was reported in ALPENA, MI. Original Owner. Vehicle was purchased on Dec 01, 2094. Vehicle was using ANTI-LOCK BRAKES.Vehicle was using Cruise Control.Dodge Wagon 1995 drive type:RWD. FUEL SYSTEM:N/A. FUEL TYPE: GAS.
Car-and-Safety.com